UVLE UV Systems are a Safe, Clean, Effective, Economical and Healthy option for sanitizing water. Low Cost: Capital and operating cost is low compared to other disinfection methods. Simple to Install and Operate: No moving parts to wear out, installation flexibility. Effective: Exposure to UV light triggers a reaction almost instantly, more effective than clorination and other methods of disinfection on a wide range of pathogens. Efficiency can be as high as 99.99% Safe and Chemical Free: UV Light does not result in the creation of harmful disinfecton by-products, UV does not alter water chemistry or other parmeters, such as PH, Taste, Odour, Colour, etc..
Benefits: Note: The VH410 replaces the Sterilight S12Q-PA and SC-320 systems.Product Details
Powerful, yet compact UV disinfection system designed for the larger home or light commercial application, for flow rates up 18 gpm (70 lpm).
Discription Technical Data
Blackcomb fan package, fits 3½" chambers, includes fan, power source and clamp.
This integral control module allows for a 4-20mA connection on all Blackcomb 5.1/6.1 products. This device will allow for a 4-20mA signal transfer of the UV output to a remote device such as a data logger or computer. Simply plug the supplied cable into the "IEP" port on the UV sensor module (or daisy chain to any other module used in the system). Two screw the terminals are supplied to connect the wire that leads to the receiving end of the signal. As the distance required is unknown, no wire is supplied with this system, however 16-22 AWG is required.
For use in all Blackcomb 5.1/6.1 products. Install a NORMALLY CLOSED line voltage solenoid valve (not supplied) into this junction box. Connect the power and the supplied lead to the controller. Please note that when this device is connected to a blackcomb 5.1 system (without the UV model), then the solenoid will close on a lamp failure mode only. When used on a Blackcomb 6.1 system the solenoid will close when the UV level drops below 50%. Also note that in cases where emergency use of untreated water is required, the controller an be placed into a manual override mode allowing for the flow of water in an alarm condition.